Manual x/e-touchPANEL 02 | 01-2021 | 2.9 | en
Appendix
c
117 / 118
1.
2.
3.
1.
2.
3.
4.
5.
8.4. Help in the case of problems
8.4.1. Reset of settings
All settings can be reset to the factory default values. In this case, the addressing of the emergency units or
operating devices is also deleted.
Click on the "Main menu" symbol.
-> The "Main menu" is displayed
Click on the "Configuration" button
-> The "Configuration" page is displayed
Click on the "System" tab
-> The "System" tab is displayed
Click on the "Reset to factory defaults" button.
-> System is reset to factory defaults.
8.4.2. Ethernet connection cannot be established
8.4.3. DALI scenes cannot be defined
Click on the "Main menu" symbol.
-> The "Main menu" is displayed
Ensure that each device is only assigned to one group.
Click on the "Addressing/grouping" button.
Click on the "Folder" button and check all groups one after another. Ensure that the device is assigned to a
group.
Change the grouping as required.
...
Ensure that a crossed network cable was used for a point-to-point connection (x/e-touchPANEL directly
connected to the PC/laptop).
_
Ensure that the IP address entered in the x/e-touchPANEL and in the browser is correct, see "
_
Ensure that no Firewall or protection software is disturbing the connection. If necessary, contact your IT
specialist
_
I
NOTICE
To configure a scene, only one operating device is to be assigned to a group because otherwise conflicts may
occur.
