Pr
eparation befor
e application
Preparation before washing
Adjustable foot
(extend when clockwise
rotating and shorten when
counterclockwise rotating)
Knob of adjustable foot
( loosen by clockwise
rotating tighten by
counterclockwise
rotating)
In the back
1
!
Leveling of washer
Before operation,check that the washer is both level and stable on the floor,
otherwise the washer barrel will incline and knock against the cabinet,
(Hint:Use a spirit level aligned with the top edge of the metal
casing both at the front and side to check if
the machine is level).
Adjust the adjustable feet at the front and right
hand side rear of the unit as per the diagram.
To adjust:
a) Loosen the outer grey knob of adjustable
foot by turning in a clockwise direction
b) Slightly incline the washer and rotate the
black rubber foot clockwise to extend and
counter-clockwise to retract.
c) Once the machine is both level and stable
on all four corners lock each adjustable foot
by rotating the outer grey knob in a counter-
clockwise direction.
Note:If the floor is severely out of level then
correction will need to be made to the floor surface.
2
!
Install the hot and cold water inlet hoses.
3
!
Connect machine to power outlet.
4
!
Turn on the water supply
5
!
Hang the upper drain hose on the side
of the laundry sink or tub
6
!
Load the washer with a suitable wash
load and amount of washing powder
When washing,ensure that all coins,keys and other hard items
removed form
wash articles and close zip fasteners to prevent damage to clothes and machine.
Only machine washable items should be put into the washer.Wash delicate items
in a suitable wash bag.
are
>750mm
Note:
The water will overflow
when the height of the
drain hose under 750mm.
Tightly screw another end of water inlet
hose on water inlet valve . (with rubber
seal ring inside).
Note: When tightening the clamping nut,
evenly apply the force and do not twist
the water inlet valve or hose to avoid
breaking of water inlet valve joint.
Clamping
nut
Hot water
Cold water
Water inlet hose
