Trigano Auvents Panoramic 300, Erection Instructions

RECOMMENDATIONS

•  Assemble the awning at home before setting off on your trip in order to familiarise yourself 

with its assembly and ensure you have not forgotten anything.

• Choose preferably a smooth, level plot and remove all stones, twigs, etc…
• Avoid placing the entrance towards the wind.
• Close all zippers before assembly.
• Open all zippers before packing up your awning.
•  Condensation (natural phenomenon) is caused by the humidity given off by the occupants, 

the air and ground. Droplets therefore form on the inside surface of the awning and may give 

the impression that the awning is leaking, but this is not the case!

• In order to limit this condensation, simply air the awning as much as possible using the double 

doors with mosquito netting. The roof lining will help to reduce the condensation.

BEFORE ASSEMBLY 

• Remove all items from the bag and place them on the ground.

ABOUT THE INFLATABLE FRAME 

•  The frame of the PANORAMIC 300  awning is composed of  

4 inflatable poles, whereas the PANORAMIC 410 awning 

has 6.

•  These  inflatable  poles  are  placed  in  the  zipped  covers. 

They are therefore easy to replace.

•  The  poles  are  made  of  polyurethane  (TPU),  a  material 

which resists wear and its porosity to air is almost zero.

•  To provide efficient protection against bursting, each TPU 

pole is covered with a high-resistance protection made of 

polyethylene-lined OXFORD polyester. This cover is closed 

with a zipper.

THE 2 PULLS OF THE ZIPPER ARE AT-

TACHED TOGETHER WITH A PADLOCK. 

THIS PADLOCK MUST NEVER BE REMO-

VED AS THIS WILL RESULT IN THE TUBE 

BURSTING DURING INFLATION. CUR-

SORS OF EXTRA TUBES ARE ATTACHED 

TOGETHER WITH A BENDING . DO NOT 

REMOVE THIS BENDING AS WELL.

ATTENTION

ENGLISH

- 12 -

- 13 -

cover

sleeve

Zipper

Notice PANORAMIC 300 ET 410.indd   13

06/02/2018   16:34