20
January, 2021
Cellular communicator G16T_LTE-M
•
For connection over IP
–
software receiver IPcom Windows/Linux, hardware IP/SMS receiver RL14 or multichannel
receiver RM14.
“Primary channel” settings group
•
Communication type
–
select which connection method to monitoring station receiver will be used (IP).
•
Protocol
–
select in which coding the events should be sent:
TRK8
(to TRIKDIS receivers),
SIA DC-09
(to receivers, which
receive events encoded in SIA DC-09 format).
•
Encryption key
–
16-digit message encryption key.
The key written to the communicator must match the receiver’s key.
•
Domain or IP
–
enter the domain or IP address of the receiver.
•
Port
–
enter the network port number of the receiver.
•
TCP or UDP
–
select in which protocol (TCP or UDP) the events should be sent.
“Primary channel Backup” settings group
Enable the backup channel mode to send events via backup channel if connection via primary channel is lost. Backup channel
settings are same as described above.
“Parallel channel” settings group
Through this channel events are transmitted in parallel with the primary channel. When the second channel is enabled, events
can be sent simultaneously to two receivers (e.g., local and centralized monitoring stations). Parallel channel settings are the
same as described above.
“Settings” tab
“Settings”
settings group
•
Test period
- TEST event period for testing the connection. Test events are sent as Contact ID messages and forwarded
to the monitoring software.
•
IP ping period
–
period for sending internal PING heartbeats. These messages are only sent via IP channel. The receiver
will not forward PING messages to the monitoring software to avoid overloading it. Notifications will only be sent to the
monitoring software if the receiver fails to receive PING messages from the device within the set time.
By default, the receiver will send a
“
Connection lost”
notification to the monitoring software if the PING message is not
received over a time period three times longer than set in the communicator. E.g. if the PING period is set for 3 minutes,
the receiver will send the
“Connection lost”
notification if PING message is not received within 9 minutes.
PING heartbeats keep the active communication session between the device and the receiver. An active session is
required to be able to remotely configure and control the communicator. We recommend setting the PING period for no
more than 5 minutes.
•
Backup reporting after
- indicates the number of unsuccessful attempts to send the message via Primary channel. If
device fails to transmit specified number of times, it will connect to transmit the messages via Backup channel.
•
Return from backup after
- time after which
G16T
will attempt to reconnect and transmit messages via Primary channel.
