©1997-2015 TRIKDIS
22
www.trikdis.com
Controller GV15
Automatics control
9
Automatics control
By phone call
If DTMF code control mode is disabled:
1.
Call to the number of SIM card inserted in the controller GV15.
2.
Control command will be completed after your call is rejected by the controller.
By DTMF tone phone call
If DTMF code control mode is enabled:
1.
Call to the number of SIM card inserted in the controller GV15.
2.
Using DTMF tone codes send the control command (e.g: 1*0#). Command timeout no longer than 20
seconds.
Command structure
R * C #
R
–
controlled relay number (1 - 1st -relay, 2 - 2nd relay, 3
–
both relays together);
C
–
control command (0
–
turn off, 1
–
turn on).
E. g.: 1*0#
Value: 1
–
1st relay;
* - "*" symbol in a phone keypad;
0
–
command to "turn off";
# - "#" symbol in a phone keypad (the end of command);
3.
The control command shall be accomplished when the controller having sent a tone signal of 0.5 sec
duration will reject your phone call.
Note:
-
Your phone number must be entered in the controller administrator list and the mode All (all callers
permitted for control) shall not be used;
-
The recommendation is to describe each command as a separate contact in a mobile phone memory to
facilitate dial control. While entering Controller GV15 SIM card number it is necessary to enter a pause
icon (by pressing and holding "*" phone button) and the command. The phone number will look in such
a way:
+xxxxxxxxxxxp1*0#
(for Android system)
+xxxxxxxxxxx,1*0#
(for IOs system)
-
In case of an error during manual entering of the command, press "#" button (the end of command). After
a false command signal (three short tone signals) is heard the command can be re-entered (a new count
of 20 sec. command holding time shall be started).
