Gebrüder TRILETY Ges.m.b.H.
MCK-M31 1.02
09/ 2018
* Optional equipment
Page
14
2.2
PREPARATION OF THE MULTICAR CHASSIS
The Multicar chassis that is to serve as the carrier vehicle must be suitable for the
exchangeable sweeper body and must be specially adapted for the sweeper body with
the following equipment:
•
07-4 power hydraulic
•
Hydraulic connections for operating the sweeper unit
•
Electric connections for the sweeper and controls in the cab
•
Water pipes for front brush
2.3
MOUNTING AND DEMOUNTING THE SWEEPER
The exchangeable sweeper
MCK
is designed as a quick-swap body for Multicar
chasses and can be easily and quickly mounted onto a Multicar chassis that has been
pre-fitted with the appropriate equipment with a few easy steps:
To ensure easy connection, the supply lines and cables (hydraulics, electrics, water)
are fitted with quick release couplings.
! Caution !
Special care should be taken when changing the attachment – high risk of
accidents by incorrect performance!
2.3.1
Mounting the Sweeper Unit
1. Remove the tipping platform from the vehicle using the vehicle manufacturer
instructions.
! Caution !
To prevent damage to the sweeper unit, the vehicles tipping cylinder
disconnected from the vehicle hydraulics!
2. Raise the front mounting plate completely.
3. Insert the connection between the hydraulic pressure coupling and the
pressure transfer to the rear on the front (
only applies if brush drive circuit
is not at the rear or without frontbrush = pressure forwarding)
