Using AirProjector Client
31
Connecting to AirProjector in Different Network Segment
An AirProjector located in a different network segment cannot be found by AirProjector
Client. In this case, manually add the IP address of the AirProjector to AirProjector
Client.
1.
Click the “Add AirProjector” button on the “ADVANCED SETTINGS” screen.]
2.
Click “Add” on the “Add AirProjector” screen.
3.
Enter the IP address of the AirProjector to be searched and click “OK”.
4.
The IP address is displayed on the bottom of the list in the “Add AirProjector”
screen. Check “Check status” and click “OK”.
5.
Searching the AirProjector will start. All available AirProjectors will appear on the
list of the main screen.
Assigning Nickname
A nickname can be assigned in the PC to which AirProjector is connected.
The nickname set here will appear on the standby screen of the projector when the
“Blink” button is clicked.
1.
In “Create Nickname” on the “ADVANCED SETTINGS” screen, enter a nickname
up to sixteen alphanumeric characters in the text box.
Using Remote Control Function
To use the remote control function, AirProjector and the projector must be connected in
advance using a serial cable.
From AirProjector Client, you can control your projector with the commands assigned in
advance.
Up to seven commands can be assigned on the configuration screen (“Power ON/OFF”,
which is frequently used, differs in button shape from the others).
To assign a command, set the command data and its name on the configuration screen.
Example:
Command number: “1”, Command name: “Power On”, Command data: “ABC”
Command number: “3”, Command name: “Zoom command”, Command data: “DEF”
Also refer to “Serial
Command Settings Page” in
“<8> Advanced Settings”.
