CLEANING AND LUBRICATION.
Regularly clean your Cutter rail using a dry cloth,
stubborn stains can be removed with a cloth
dampened with a little water/detergent.
Silicon spray can be used to lubricate the cutting
head slideway.
NEVER USE OIL OR SPIRITS TO LUBRICATE OR
CLEAN THE CUTTER RAIL, SOME OF THE PLASTIC
COMPONENTS AND BEARINGS MAY BE DAMAGED
CUTTING HEAD BEARINGS
The bearings used to control the sliding motion of
the CUTTING HEAD are made from a high-quality
polymer and under normal use will last for an
extremely long time. As they settle into position
you may find a slight amount of side play, this can
be removed by tightening the two adjustment
screws.
Place the long end of the 2mm Allen key provided
into any of the two grub screws and very gradually
tighten with one hand while moving the cutting
head along the cutter bar with the other. Once
you feel the sliding motion begin to tighten, undo
the screw the smallest amount, allowing the
cutting head to slide easily.
Repeat this for the other screw.
6.1
MAINTENANCE
6.1
6.2
MAINTENANCE
6.2
