TriMark 24324-03, Installation Instructions Manual

The following area can be used to document the access code 
assignments. 
 
Access code:

Teaching Additional Transmitter FOBs 

This applies only to the 

e-ASK 

system that includes the RF receiver 

door module. 
 
There are 2 ways that the receiver can be put into learn mode. The first 
requires that a CAN keypad be connected to the network. This option 
allows the receiver to be put into train mode without accessing the 
module. The 2nd option requires access to the RF receiver door 
module. 
 

Option 1 (if CAN keypad is connected to network): 

1.  Hold middle (5 / 6) button of keypad for 5 seconds. The keypad will 

beep and the LEDs will flash. 

2.  Enter authority code. Keypad will provide a sustained beep. 
3.  Press and hold (9 / 0) for 5 seconds. A double beep plays.                              

a.  The receiver module is now in FOB Learn Mode. (The LED 

under the receiver enclosure will be blinking rapidly—this will 
not be visible unless the enclosure cover is removed.) 

4.  Press lock button of the first FOB to be trained for 2 seconds. Wait 

3 seconds and press the lock button on each subsequent FOB. Up 
to 4 FOBs can work with the module at one time. 

5.  Press any button on the key pad to exit FOB learn mode. Four 

short beeps will sound and the door module will return to normal 
operation. 

6.  Verify function and range of the FOBs that were trained. 
 

4 

Access # 

Digit 1 

Digit 2 

Digit 3 

Digit 4 

Digit 5 

1 

2 

3 

4 

5