Trina Solar User Manual | Vertex Series Modules
7
The warehouse shelves should have sufficient carrying capacity and storage space, regular
inspection is required to ensure the storage safety.
If you need to store the modules in the project site, do not choose soft ground and the ground that
is easy to collapse, should choose a hard ground or a higher ground with flat surface to ensure the
module packages not collapsing and tilting for long-term storage.
In rainy weather, please fully cover the modules and pallets with a rain protection and take moisture-
proof measures on pallets and cartons to prevent collapse and moisture ingress. Under sun or wind,
remove the rain cloth to allow the package to dry as soon as possible, prevent package collapse
caused by the rain.
Do not allow the pallets to soak in rain water leading to mold and decay. The ground drainage
measures should be done first to prevent a large amount of water accumulation on the ground after
rain, causing the ground to soften, sink, etc.
Do not allow unauthorized persons to access the module storage area.
Do not leave modules unsupported or unsecured.
The modules should be centrally stored with pallet specing within 10 cm.
5
UNPACKING INTRODUCTION
5.1 UNPACKING SAFETY
Before unpacking, please check the product type, power bins, serial number and relevant
suggestions on the A4 paper of the packaging box, and read the unpacking instructions carefully.
Custom unpacking methods are prohibited.
Before unpacking, please make sure that the packaging box is in good condition, it is recommended
to use art knife to remove the packing belt and wrapping film. Violent removal is prohibited to avoid
scratching the modules in the box.
Please check that the number of modules in the box and the barcode information on the module
frame are consistent with the information on the A4 paper on the packaging box.
Please follow the recommended unpacking steps to unpack the modules. When unpacking, it must
be operated by two or more people at the same time. Always wear insulating gloves when handling
the modules.
If all the modules are not taken out after unpacking, the remaining modules shall be placed
horizontally and repackaged to prevent them from tipping. When packaging, please note that the
glass side of the bottom module should face up, the glass side of the middle modules should face
down, and the glass side of the top module should face up. Stacks of modules should contain no
more than 16 modules, and the frames should be aligned.
For matters regarding the unpacking stand supporter, please contact Trina Solar sales.
