TMCM-1210 Hardware Manual (V0.93 / 2019-FEB-13)
13
Copyright © 2015-2019 TRINAMIC Motion Control GmbH & Co. KG
6
On-Board LEDs
The board offers one LED in order to indicate board status. The function of the LED is dependent on the firmware
version. With standard TMCL firmware the green LED should be flashing slowly during operation.
B
EHAVIOR OF
LED
S WITH
S
TANDARD
TMCL
F
IRMWARE
Status
Label
Description
Heartbeat
Run
This green LED flashes slowly during operation.
GREEN LED
Figure 6.1 On-board LED
7
Reset to Factory Default Values
In order to reset all settings (e.g. incl. address and RS485 baud rate) to factory default values please follow
instruction sequence below:
1.
Switch OFF power supply.
2.
Short programming pads on bottom of PCB as shown in figure 7.1.
3.
Switch ON power supply (on-board LED should start flashing fast).
4.
Switch OFF power supply.
5.
Remove short circuit.
Figure 7.1 Reset to factory default values (bottom view of pcb)
