MANUAL DOOR HANDLING
FACTORY RESET
A factory reset will delete all codes associated with the lock, and i t will remove i t f rom your smart
home system.
If needed, the door handling process can be initiated manually. This is useful if the lock is being
moved to a different color.
1 . Remove battery pack.
2 . Press and HOLD the
Program button while
reinserting the battery
pack. Release button
once battery pack is
installed. The status LED
will f lash red and green.
3 . Press the Program button
once more.
4 . The latch bolt will extend and
retract to learn the orientation
of the door.
The Status LED will indicate
success or failure.
5.
Success:
LED f lashes
green
Failure:
LED remains
solid red
I f the Status LED indicates a
failure, see the online
Programming and
Troubleshooting Guide or call
Technical Support.
1 . Remove battery pack.
2 . Press and HOLD the
Program button while
reinserting the battery
pack. Keep holding the
button for 30 seconds
until the lock beeps
and the status LED
f lashes red.
2 . Press the Program button
once more. W hen the LED
f lashes green and you hear
one beep, the lock has
been reset.
4 . After a few seconds, the lock will initiate the
door handing process, and the latch bolt will
extend and retract to learn the orientation of the
door.
Trinity Wiring and Security Solutions
|
C o p y r i g h t © 2 0 1 9 A l a r m. c o m. A l l r i g h t s r e s e r v e d .
pg8
