www.energyabsorption.com
Revision B June 2013
www.highwayguardrail.com
30
All rights in copyright reserved
II. Detaching and Attaching the System to the Truck
1)
Detaching the System from the Truck
Be sure the TMA and the truck are on level ground
A.
Ensure the system is in the folded position.
B.
Remove the Jacks from the storage location and assemble them on the Active
Mounts as shown in Figures 24 & 25.
C.
Extend the Jacks until the weight of the system is supported.
Figure 24
D
.
Unplug the light harness and disconnect the positive and negative cables from
the pump. Unplug the Cab Switch Box at the mating connector on the TMA.
E.
Remove the Socket Hitches from the Underride Socket Receivers by removing
both 1 x 6 1/4" hitch pins and retainer pins (See Figure 26). (If the alignment is
off, making removal dif
fi
cult, it may be necessary to adjust Jacks or temporarily
disengage the TMA from the Socket Hitches. This can be done by removing the
two 1 1/4 x 7" hitch pins and retainer pins as shown in Figure 26.) Loosen the
hardware to ease interference and be sure to retighten.
F.
Move the TMA away from the truck.
Figure 25
Figure 26
