ASSEMBLY INSTRUCTIONS
Unscrew Lock Nut from bottom of FAUCET
ASSEMBLY (C) and remove Lock Nut, White
Washer and Black Flat Gasket.
From top side, make sure Metal Base w/
Gasket is on top of SINK (A) and all 4 hoses
are straight and untangled. Insert FAUCET
ASSEMBLY (C) through hole, first with Quick
Connector hose, then hot and cold water
supply hoses with metal fittings, finally the
short hose with plastic cap.
Once all hoses are carefully threaded
through hole and FAUCET ASSEMBLY (C) is
sitting flush on top of SINK (A), align faucet
handle facing towards front of SINK (A).
From under SINK (A), first slide on Black Flat
Gasket, then White Washer, then screw on
Lock Nut. Tighten Lock Nut as much as you
can by hand. If necessary, use a pipe
wrench to tighten.
Remove and discard the Plastic Cap from
short hose and push Quick Connector to
connect two ends of hoses. You should
hear a soft click to indicate secure
connection and orange release button
should return to flush with housing. You may
also give two ends of hose a soft tug to
ensure they are connected securely.
Locate Counterweight in the box, use a
Phillips screwdriver to separate two halves
of Counterweight by unscrewing screws
securing them. Make sure Spray Head is
pushed up against the spout and pull-out
hose is dangling unhindered. Re-secure
Counterweight just above the turn of pull-out
hose, on side opposite Quick Connector.
Counterweight position can be moved up to
decrease amount of Spray Head pull-out if
desired.
STEP 5
C (1)
C
On top of
the sink
Under
the sink
© 2019 TRINITY - 800.985.5506
4
Faucet Assembly (C)
Spray
Head
Metal Base
w/ Gasket
Black Flat
Gasket
White
Washer
Lock Nut
Counterweight
Quick
Connector
Remove and discard
Plastic Cap
Orange release
button
Black Flat
Gasket
White
Washer
Lock Nut
Black Flat
Gasket
White
Washer
Lock Nut
1
4
2
3
