Triple S Ultron 20BA, Owner'S Manual

10

SSS Ultron 20BA / Ultron 20TD / Ultron 20TO

OPERATOR MANUAL

daIly maIntenance

1.  Remove pad driver/ brush and clean with 

approved cleaner.

2.  Drain recovery and solution tanks completely 

and rinse out with clean water. Visually check 

the recovery tank for debris and clean out as 

necessary.

3. 

Raise the squeegee assembly off floor and wipe 

it down with a damp towel. Be sure to store the 

squeegee in the up position.

4. 

Remove the float shut-off assembly and rinse it 

out with clean water.

5.  Clean machine with an approved cleaner and a 

damp towel.

6.  Recharge the batteries.

7.  Check the condition of the squeegee blade 

wiping edge, rotate blade if worn.

montHly maIntenance

1.  Clean the battery tops to prevent corrosion.

2.  Check for loose battery cable connections.

3.  Inspect and clean the recovery tank cover seal. 

Replace it if damaged.

4.  Lubricate all grease points and pivot points with 

silicon spray and approved grease.

5.  Check the machine for loose nuts and bolts.

6.  Check the machine for leaks.

oRBItal Head maIntenance

For Orbital head, you should have checked the 

eight isolators located in the Orbital head every 

300 hours. 

1. 

Using a flashlight, do a visual inspection of the 

isolators by looking through the opening in the 

Orbital head and checking for wear or damage 

to four isolators in the front and four in the 

rear of the Orbital head. The locations of the 

isolators are show below. 

2.  If any of the ten isolators show signs of wear, 

degradation or damage, contact a Triple S 

Dealer to replace all ten isolators.

motoR maIntenance

1.  Contact a Triple S Dealer for any motor 

maintenance.

2.  Motor should have the brushes checked every 

250 hours. Brushes should be replaced when 

they are worn to a length of 10 mm or less.

BatteRy maIntenance

          WaRnInG: Batteries emit hydrogen 

gas and an explosion or fire can result. Keep 

sparks and fire away from batteries at all times.

          WARNING: Whenever servicing batteries, 

be sure to wear protective gloves. Avoid 

contact with battery acid at all times.

NOTE: For the best machine performance, keep 

batteries charged at all times. Do not let them sit in 

a discharged condition.

1.  Always follow the battery charging directions as 

outlined in the BATTERY CHARGING section of 

this manual.

2.  Keep battery tops and terminals free from 

corrosion. A strong solution of baking soda 

and water is the best way to keep the batteries 

corrosion free. DO NOT ALLOW THE BAKING 

SODA / WATER SOLUTION TO ENTER THE 

BATTERY CELLS.

3.  Use a wire brush with the baking soda solution 

to properly clean the battery posts and 

connections.

4.  Check battery connections for wear and loose 

terminals. Replace if necessary.

macHIne StoRaGe

1.  Always store the machine indoors.

2.  Always store the machine in a dry area.

3.  Always store the machine in its upright position.

4.  Always store the machine with the pad driver/ 

brush raised off the floor.

5.  Always store the machine with the squeegee 

assembly raised off the floor.

6.  If storing in an area which may reach freezing 

temperatures, be sure to drain all fluids from the 

machine prior to storage. Any damage caused 

by freezing temperatures will not be covered by 

the warranty.

7.  Drain the recovery tank.

8. 

Drain the solution tank of all fluid.