13
Triple Solar assembly instruction PVT heat pump panels March 2020
7. Installation of the panels
Placing the TS clamping profile
The TS clamping profile must be prepared on the mounting rails before the heat pump panels are laid on
them. The TS clamping profile is mounted in the middle behind the heat pump panel and is only pushed
into place over the panel profile after the panels have been installed. The panel profile is located at the
back side of the heat pump panels. This TS clamping profile is required due to wind and tensile loads at
the centre of the heat pump panel. (The aluminium frame that surrounds PV panels and provides this
rigidity is missing in the heat pump panels).
•
Insert the clamping profile connector into the rail and turn it a quarter turn.
•
Slide the TS clamping profile over the connector. Make sure it is placed in the right direction to fit later in
the panel profile.
Figure 7.1-a
–
Insert TS clamping profile slide connector into the mounting rail
Figure 7.1-b sliding the TS clamping profile over the TS clamping profile slide
connector
