Avoid damage to probe of the product
Note: don’t put the product close to strong heat source directly
**NOTE:
**
Product Clicking
– Sensor is automatically calibrating for
image,
When the product works, there is light sound of clicking
every several seconds. This is normal and is calibrating
when the lens captures images and senses temperature
changes.
Charging
–
Avoid overcharging (over 24 hours) the battery
and remove Power Adaptor when not charging. Use only the
charging cable and adaptor that the unit is shipped with or
make sure it is the same 5 V/2A max spec.
Water and Condensation
–
It is best to avoid water and
condensation when storing the unit.
Cleaning
–
It is best to use water-based soap to clean and
not abrasive solutions.
Lens Maintenance and Cleaning
– Take care and be gentle
when cleaning the lens as it is treated with an anti-reflection
coating. Use an alcohol-based cleaning solution and a lint
free soft cloth to remove dust and dirt. Compressed air is also
an alternative that works well.
Charging Battery
Use USB data line to charge:
The product has built-in chargeable 26650 lithium batteries.
When the battery level is low, the top right of the screen will display
“
”. Please charge in time through Micro USB interface
When the product is off, you can charge
）
.
Pull off the USB line after fully charging.
To make the lithium-ion battery can play the perfect performance:
Don’t place the battery on the charger exceeding 24 hours.
The thermal imaging device should be charged for two hours
at least every three months so as to extend the battery service
life to the greatest extent.
Don’t try to charge the battery in extremely cold environment.
