Operation
POWER ON/OFF
•
Press and hold the “ ” button for more than 3
seconds to turn the Thermal Imaging on or off.
Main Display
•
After powering on the power, open the lens protection
cover, the screen shows the thermal imaging status.
•
**Note: Time adjustment may be required when you move the
camera between environments with widely varying ambient temperatures.
Visible, Fused and Thermal Image Modes
Switching between infrared thermal image and visible image
Press “ ” or “ ” key to switch the degree of fusion between inferred
thermal images and visible images (the degree of fusion is 0%, 25%, 50%,
75% and 100%)
Maximum and Minimum Temperature
Display
The highest/ and lowest temperature is shown at the bottom
of the screen over the image
after normal start up, pressing the “ ” button will toggle
between displaying and hiding this information.
Image capture
•
Quick pull of the image capture trigger to capture.
When the capture is successful, the screen will
show the prompt “Save image?”. If you want to
save the image, select “Yes” and press the
“SELECT/ENTER” button. The image will be
stored. If you do not want to save the image you
can select “No” and the image will be deleted.
