6
WARNING
• When installing wall mounts onto a concrete
masonry unit (also known as a CMU or
“cinder block”), verify that the actual concrete
thickness is at least 35mm (1-3/8”) in order
to hold the concrete anchors. DO NOT
DRILL INTO MORTAR JOINTS! Be sure to
mount the assembled wall-mount plate with
the included concrete anchors, D6 washers
and anchor bolts onto solid sections of the
blocks. The solid sections can generally be
found 25mm (1”) toward the middle of the
block from either end. An electric drill on a
slow setting is suggested to drill the hole
rather than a hammer drill so as to avoid
breaking out the back of the hole when
entering a hollow section.
• Installers must verify the supporting surface
will safely support the combined load of the
equipment and all attached hardware and
components.
Assembly
2b
Mount on Solid Brick and Concrete Block
Mark the
exact location of
mounting holes
Screw the assembled
wall plate onto the wall
Drill pilot holes
1
2
60mm
60mm
(2.4")
(2.4")
O 10mm
O 10mm
(O 3/8")
(O 3/8")
W-C
W-A
W-B
Summary of Contents for 037332266101
Page 4: ...4 Assembly 1 Assemble the Wall Plate A B E E ...
Page 12: ...12 Ensamble 1 Ensamble la Placa de Pared A B E E ...
Page 20: ...20 Assemblage 1 Assemblage de la plaque murale A B E E ...
Page 28: ...28 Порядоксборки 1 Сборкапластиныдлякреплениякстене A B E E ...
