6
Basic Operation (Rear Panel)
continued
Tel/DSL Protection Jacks (select models only):
RJ-style jacks protect
connected equipment by stopping surges on a single phone, fax or
modem line. Connect a phone cord from the wall jack directly to the Tel/
DSL jack labeled “IN.” Connect a phone cord from the Tel/DSL jack
labeled “OUT” directly to the device to be protected. The UPS system
must always be the first item connected in line from the wall jack. The
UPS system must be plugged into a 3-wire grounded AC outlet for Tel/
DSL line surge protection to work. Connecting your equipment to these
jacks is optional. Your UPS will work properly without this connection.
Coaxial Protection Jacks (select models only):
Gold-plated coaxial
“F” connectors protect connected equipment by stopping surges on a
single DSS satellite, cable or antenna line. Connect a coaxial cable
from the wall jack directly to the coaxial jack labeled “IN.” Connect a
coaxial cable from the coaxial jack labeled “OUT” directly to the device
to be protected. The UPS system must always be the first item
connected in line from the coaxial wall jack. The UPS system must be
plugged into a 3-wire grounded AC outlet for coaxial line surge
protection to work. Make sure cables connected to satellite dishes,
antennas, etc. are also grounded. Connecting your equipment to these
jacks is optional. Your UPS will work properly without this connection.
Battery Replacement Door:
Under normal conditions, the original
battery in your UPS will last several years. Battery replacement should be
performed only by qualified service personnel. Refer to "Battery Warnings"
in the Safety section. Should your UPS require battery replacement, visit
Tripp Lite on the Web at www.tripplite.com/support/battery/index.cfm to
locate the specific replacement battery for your UPS.
Storage & Service
Storage
To avoid battery drain, all connected equipment should be turned off and disconnected from the UPS.
Press and hold the ON/OFF button for one second. Your UPS will be completely turned off (deactivated),
and will be ready for storage. If you plan on storing your UPS for an extended period, fully recharge the
UPS batteries every three months. Plug the UPS into a live AC outlet, turn it on by pressing and holding
the ON/OFF button for one second, and allow the batteries to recharge for 24 hours. If you leave your
UPS batteries discharged for a long period of time, they will suffer a permanent loss of capacity.
Service
A variety of Extended Warranty and On-Site Service Programs are available from Tripp Lite. For
more information on service, visit www.tripplite.com/support. Before returning your product for
service, follow these steps:
1. Review the installation and operation procedures in this manual to insure that the service
problem does not originate from a misreading of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit
www.tripplite.com/support.
3. If the problem requires service, visit www.tripplite.com/support and click the Product Returns link.
From here you can request a Returned Material Authorization (RMA) number, which is required
for service. This simple on-line form will ask for your unit’s model and serial numbers, along with
other general purchaser information. The RMA number, along with shipping instructions will be
emailed to you. Any damages (direct, indirect, special or consequential) to the product incurred
during shipment to Tripp Lite or an authorized Tripp Lite service center is not covered under
warranty. Products shipped to Tripp Lite or an authorized Tripp Lite service center must have
transportation charges prepaid. Mark the RMA number on the outside of the package. If the
product is within its warranty period, enclose a copy of your sales receipt. Return the product for
service using an insured carrier to the address given to you when you request the RMA.
Coaxial Jacks
8
Tel/DSL Jacks
7
201207108 93-2663.indd 6
9/4/2012 3:15:58 PM
