5
Installation
2-2
Input Power Cord Connection:
Attach the cable clamp to the PDU
using the included screws
A
.
Attach the included power cord
to the PDU by inserting the IEC
60320 C19 connector
B
of the
power cord into the cable clamp
and IEC 60320 C20 power inlet
C
located near the end of the
PDU. Install the included screw
D
on the cable clamp to secure the
power cord connection. Connect
the other end of the input power
cord to a compatible source of AC
power, such as a UPS system, PDU
or utility outlet.
2-3
3
2-2
B
C
A
D
A
4
Note:
When connecting the PDU, it should be provided with over-current protection and a
maximum 20A branch-rated over-current protection device.
2-3
Attach the input plug of the PDU
to a grounded outlet:
Insert the
plug directly into a grounded outlet
that does not share a circuit with
a heavy electrical load (such as an
air conditioner or refrigerator).
3
Attach equipment to the PDU
Do not exceed the load rating
of the PDU. The total electrical
current used by the PDU will be
displayed on the digital meter in
amperes.
4
Optional Cord Retention Procedure
Use the included C14 sleeves to
secure plugs to receptacles. Attach
the sleeve to the plug, making sure
that the pull tabs
A
remain outside
the plug and that the fit is secure.
To unplug equipment properly, use
the pull tabs to remove the plug
and sleeve from the receptacle.
18-11-316-933051.indb 5
2/11/2019 2:06:48 PM
