background image

2

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed during the 

installation, operation and storage of this product. Failure to heed these warnings 

may affect the warranty.

UPS Location Warnings

•  Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust 

or direct sunlight.

•  For best performance, keep the indoor temperature between 32º F and 104º F  

(0º C and 40º C).

•  Leave adequate space around all sides of the UPS for proper ventilation.
•  Only set the UPS upright on a sturdy flat surface. Do not block fans or ventilation holes, as 

this will seriously inhibit the unit's internal cooling and cause product damage not covered 

under warranty.

UPS Connection Warnings

•  Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS into 

itself; this will damage the UPS.

•  Do not modify the UPS plug, and do not use an adaptor that would eliminate the UPS 

ground connection.

•  Do not use extension cords to connect the UPS to an AC outlet.
•  If the UPS receives power from a motor-powered AC generator, the generator must provide 

clean, filtered, computer-grade output.

•  The mains socket-outlet that supplies the UPS should be easily accessible and located near 

the UPS.

•  For use on a TN power distribution system.

Equipment Connection Warnings

Short-circuit backup protection and overcurrent protection are provided by 

the building installation. 
To reduce the risk of fire, connect only to a circuit-provided branch circuit 

overcurrent protection. The plug on the power supply cord is intended to 

serve as the disconnect device. Be sure the socket-outlet is installed near 

the equipment and is made easily accessible.

•  Use of this equipment in life support applications where failure of this equipment can 

reasonably be expected to cause the failure of the life support equipment or to significantly 
affect its safety or effectiveness is not recommended. 

•  Do not connect surge protectors or extension cords to the output of your UPS. This might 

damage the UPS and may affect the surge protector and UPS warranties.

Important Safety Instructions

Reviews: