TMDS
UP TO 125 ft. (Cat6)
UP TO 75 ft. (Cat5)
LOCAL
TRANSMITTER
BLU-RAY
1080p (6o Hz)
1080p (6o Hz)
REMOTE
RECEIVER
DDC
B125-101-60-WP Installation Diagram
3
1
Connect the HDMI source to the HDMI input on the local transmitter
unit.
2
Connect the
TMDS
RJ45 port on the local transmitter to the
TMDS
RJ45 port on the remote receiver using Cat5e/6 cable.
Note:
See the installation diagrams for maximum extension
distance at 1080p (60Hz) video resolutions.
3
Connect the
DDC
RJ45 port on the local transmitter to the
DDC
RJ45 port on the remote receiver using Cat5e/6 cable.
Note:
See the installation diagrams for maximum extension
distance at 1080p (60Hz) video resolutions.
4
Connect the HDMI output on the remote receiver to the HDMI monitor.
5
Connect the external power supply to the remote receiver, and then
plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power
Supply (UPS), or Power Distribution Unit (PDU). The Green LEDs on
both the local and remote units will illuminate to indicate that power
is being received. The Orange LED on the remote unit will illuminate
to indicate that a connection has been made with the local unit via
Cat5e/6 cable.
6
Turn on the power to the HDMI source. The Orange LED on the local
unit will illuminate to indicate it is receiving a signal from the source.
7
If necessary, use the equalization control to adjust the video image.
Note:
An improper Equalization setting can result in no image being
displayed at all. Try each Equalization setting until an acceptable
picture is displayed.
Installation and Operation
201109193-93-3144.indd 3
10/7/2011 2:29:40 PM
