26
Extender/Splitter Daisy-Chain with
Remote/Repeater Installation
(B126-004 only)
11
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first
remote/repeater unit to the RJ45 INPUT port on a second remote/
repeater unit.
12
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit that you just added using a Tripp Lite P568-Series HDMI Cable.
13
Connect the external power supply to the remote/repeater unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
power LED and the green RJ45 LEDs illuminate to indicate the unit
is receiving power.
14
To add a third remote/repeater unit, repeat steps 11 through 13. To
finish your installation with a B126-1A0 or B126-1A0-WP-1 remote
receiver unit, proceed to step 15.
15
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last
remote/repeater unit to the RJ45 INPUT port on a B126-1A0 or
B126-1A0-WP-1 remote receiver unit.
16
Connect a monitor to the HDMI OUTPUT port on the remote receiver
unit using a Tripp Lite P568-Series HDMI Cable.
17
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
LED illuminates to indicate the unit is receiving power from the
external power supply. The orange LED illuminates to indicate the
unit is connected to a powered ON remote/repeater unit.
18
Repeat steps 8 through 17 for each additional RJ45 output port on
the local transmitter units.
19
Turn on the power to the HDMI source. The orange RJ45 LEDs on
the local units illuminate to indicate a signal is being received from
the source.
201109206-93-3023-EN.indd 26
10/24/2011 10:01:26 AM
