6
Storage & Service
Storage
First turn your UPS OFF and disconnect its power cord from the wall outlet.
Then disconnect all equipment to avoid battery drain. If you plan on storing your
UPS for an extended period of time, fully recharge the UPS batteries once every
three months by plugging the UPS into a live AC outlet and letting the UPS
charge for 4 to 6 hours. If you leave your UPS batteries discharged for an
extended period of time, they will suffer a permanent loss of capacity.
Service
If returning your UPS for service, contact your local Tripp Lite dealer or
distributor. They will refer you to a service center. Please carefully pack the UPS
using the ORIGINAL PACKING MATERIAL that came with the unit. Enclose a
letter describing the symptoms of the problem. If the UPS is within the
warranty period, enclose a copy of your sales receipt.
Specifications
OmniSmart INT 300 PNP
OmniSmart INT 500 PNP
OmniSmart INT 700 PNP
Output Capacity (VA/Watts):
300/180
500/280
700/425
Battery Runtime (Half Load/
Full Load) Minutes:
17/5
17/5
17/5
Typical Runtime (Desktop
PC/15 in. monitor) Minutes:
30
30
45
Battery Recharge Time:
2-4 hrs.
2-4 hrs.
2-4 hrs.
Approvals:
UL, cUL, CE
UL, cUL, CE
UL, cUL, CE
Modem/Fax Protection
(starts at 260V):
1 line
1 line
2 line
OmniSmart INT 1000 PNP
OmniSmart INT 1400 PNP
Output Capacity (VA/Watts):
1000/680
1400/940
Battery Runtime (Half Load/
Full Load) Minutes:
23/7
24/8
Typical Runtime (Desktop
PC/15 in. monitor) Minutes:
55
75
Battery Recharge Time:
2-4 hrs.
2-4 hrs..
Approvals:
UL, cUL, CE
UL, cUL, CE
Modem/Fax Protection
(starts at 260V):
—
—
OmniPro INT 280
OmniPro INT 450 PNP
Output Capacity (VA/Watts):
280/175
450/280
Battery Runtime (Half Load/
Full Load) Minutes:
17/5
17/5
Typical Runtime (Desktop
PC/15 in. monitor) Minutes:
15
30
Battery Recharge Time:
2-4 hrs.
2-4- hrs.
Approvals:
UL, cUL, CE
UL, cUL, CE
Modem/Fax Protection
(starts at 260V):
—
—
ALL MODELS:
Input Voltage, Frequency (230V, 50/60 Hz); On-Line Input Voltage Range (144 - 282 volts); Voltage-Regulated Output Voltage Range
(230V +6% / -12%); On Battery Output Voltage Range (230V +/- 5%); Output Waveform Line Mode (filtered sinewave); Output Waveform
Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC
Protection Modes (H to N, H to G, N to G).
9906151 OmniSmart OmniPro 230V Owner's Manual.p65
9/30/99, 1:47 PM
6
