136
Информация о состоянии батареи
Отображает емкость аккумуляторной батареи в виде интервалов 0-25%, 26-50%, 51-75% и 76-100%.
Указывает на то, что батарея не подключена.
Отображает низкий уровень заряда батареи и низкое напряжение батареи.
Информация о входном напряжении и напряжении батареи
Отображает входное напряжение/частоту или напряжение батареи.
VAC: выходное напряжение, VDC: напряжение батареи, Hz: частота
4.3 Звуковая сигнализация
Описание
Состояние аварийной сигнализации
Возможность отключения
Статус ИБП
Режим работы по обходной цепи
Издает одиночный звуковой сигнал каждые две минуты.
Да
Режим работы от батарей
Издает одиночный звуковой сигнал каждые 4 секунды.
Режим отказа
Издает непрерывный звуковой сигнал.
Предупредительные сигналы
Перегрузка
Издает двойной звуковой сигнал каждую секунду.
Нет
Все остальные предупреждения
Издает одиночный звуковой сигнал каждую секунду.
Отказ
Все
Издает непрерывный звуковой сигнал.
Да
4.4 Порядок эксплуатации одиночного ИБП
4.4.1 Включение ИБП (режим он-лайн)
1) Убедитесь в правильности подключения источника питания. При наличии внешнего блока аккумуляторных батарей установите выключатель батарейного блока в положение “ON”
("ВКЛ"), а затем переведите входной выключатель ИБП в положение “ON” ("ВКЛ"). В этот момент включается вентилятор, и ИБП переходит в режим включения питания для выполнения
инициализации. Через несколько секунд ИБП переходит в режим работы по обходной цепи и подает электропитание на подключенные к нему нагрузки через обходную цепь.
Примечание.
В режиме работы по обходной цепи ИБП не обеспечивает защиту нагрузки. Для обеспечения защиты подключенных устройств включите ИБП как показано в Шаге 2.
2) Для включения ИБП нажмите на кнопку “ON" ("ВКЛ") и удерживайте ее в течение 0,5 с. При этом издается короткий одиночный сигнал.
3) Через несколько секунд ИБП переходит в режим он-лайн. В случае отклонения параметров сетевого питания от нормы ИБП обеспечивает бесперебойное функционирование в
режиме питания от батарей.
Примечание.
При уменьшении заряда батарей до определенного уровня в режиме работы от батарей происходит автоматическое отключение ИБП. Сразу после восстановления сетевого
электропитания ИБП снова запускается в режиме он-лайн.
4.4.2 Включение ИБП без источника сетевого питания (режим работы от батарей)
1) При использовании внешнего блока аккумуляторных батарей убедитесь в правильности подключения двух линеек батарей, прежде чем перевести выключатель батарейного
блока в положение “ON” ("ВКЛ").
2) Переведите выключатель батарейного блока в положение “ON” ("ВКЛ").
3) Нажмите на кнопку “ON” ("ВКЛ") для установки параметров питания ИБП. ИБП переходит в режим включения питания. После инициализации ИБП переходит в режим No
Output/Standby (Блокировка выхода/Ожидание). После этого нажмите на кнопку “ON" ("ВКЛ") и удерживайте ее в течение 0,5 с для включения ИБП. При этом издается короткий
одиночный сигнал.
4) Через несколько секунд ИБП включится и перейдет в режим работы от батарей.
4. Порядок эксплуатации
Summary of Contents for S3M30KX
