7
Basic Operation
continued
Other UPS Features (Rear Panel)
15 amp/120V
NEMA 5-15R
AC Receptacles:
Your UPS features 15-amp AC outlets. These output recep-
tacles, provide your connected equipment with AC line power during normal
operation and battery power during blackouts and brownouts. The UPS protects
equipment connected to these receptacles against damaging surges and line
noise. If you have a serial or USB connection to your UPS, you can remotely
reboot connected equipment by turning the receptacles OFF and ON using Tripp
Lite's PowerAlert Software.
Communications Ports (USB or RS-232):
These ports connect your UPS to any
workstation or server. Use with Tripp Lite’s PowerAlert Software and included
cables to enable your computer to automatically save open files and shut down
equipment during a blackout. Also use PowerAlert Software to monitor a wide
variety of AC line power and UPS operating conditions. Consult your
PowerAlert Software manual or contact Tripp Lite Customer Support for more
information. See “USB and RS-232 Serial Communications” in the “Optional
Installation” section for installation instructions.
EPO (Emergency Power Off) Port:
Your UPS features a EPO port that may
be used to connect the UPS to a contact closure switch to enable emergency
inverter shutdown. See Optional Installation.
Accessory Slot:
Remove the small cover panel from this slot to install optional
accessories to remotely monitor and control your UPS. Refer to your accessory’s
manual for installation instructions. Contact Tripp Lite Customer Support at
(773) 869-1234 for more information, including a list of available SNMP, network
management and connectivity products.
Input Breaker:
Protect your electrical circuit from overcurrent draw from
the UPS load. If this breaker trips, remove some of the load, then reset it by
pressing the breaker in.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 7
Summary of Contents for SMART700DV
Page 11: ...11...
