23
Operation
continued
Output Settings – Voltage
Note: Any output settings change requires a UPS power cycle.
From the SETUP MENU screen, scroll DOWN to reach the OUTPUT SETTING screen. Press ON to access the OUTPUT VOLTAGE
screen, then press ON again. Scroll UP or DOWN to choose among 5 voltage values: 200V, 208V, 220V, 230V or 240V. Press ON to
save the setting. The default setting is 208V.
UPS Settings
continued
* Note: This is the default screen.
Output Settings – Frequency Converter
From the SETUP MENU screen, scroll DOWN to reach the OUTPUT SETTING screen. Press ON to access the OUTPUT VOLTAGE
screen, then press DOWN to access the FREQ CONVERTER screen, then press ON. Scroll UP or DOWN to choose among 3 settings:
DISABLE, 50 Hz or 60 Hz. Press ON to save the selection. When the FREQ CONVERTER function is disabled, the UPS system will
automatically detect input frequency and select 50 Hz or 60 Hz to match the input. The default setting is DISABLE.
Note: It is recommended that you leave the Frequency Converter in DISABLE mode when using the 10K Transformer.
*
201102089 93-2982.indb 23
7/11/2011 3:49:33 PM
