Connect your computer to
the UPS, and the UPS to an
electrical outlet.
1. Unplug your computer’s power cord from both
your AC outlet and your computer’s AC input.
2. Insert the female plug of the power cord that
came with your UPS (A) into your computer’s AC
input. Insert the UPS cord’s male plug into any of
your UPS’s female output receptacles.
3. Insert the female plug of your computer’s cord
(B) into your UPS’s AC input. Insert the male
plug of your computer’s cord into your AC outlet.
Plug your computer, monitor
and other critical devices
into the UPS's Battery-
Supported Receptacles.*
Plug a printer or other
peripheral equipment into
your UPS's Surge-Only
Receptacle.
–Optional**–
Using provided Tripp Lite cable,
connect the serial port of your computer
to the serial port of your UPS. Load
software and run installation program
appropriate to your operating system.
Turn your UPS ON
by pressing the Main Power
Switch, holding it for
3 seconds and then
releasing it.***
* Your UPS is designed to support only computer
equipment. You will overload your UPS if you connect
household appliances, laser printers or surge suppressors
to the UPS's Battery-Supported Receptacles.
** DB9 port connection is optional. Your UPS will function
properly without this connection.
*** The UPS will execute a 10-second self-test. The
"Normal" LED will illuminate and the UPS will emit one
beep to indicate normal operation.
3
2
1
Connection
Cords and receptacles are available from
Tripp Lite to accomodate most outlet
configurations. If rewiring is necessary,
refer to the Wire Color-Code Chart on page 8.
UPS OUTLER MAX LOAD 450VA 270w
SURGE ONLY
200004074 Smart 450 RTI 230V OM.p65
4/14/00, 3:11 PM
4
