unattended shutdown, activate self-test and 10 second reboot of connected equipment
3 individual customized load management receptacles can be individually powered off and back on again via software interface to reboot
remote equipment or shed less critical loads to extend battery runtime for the most critical equipment
Built-in Emergency Power Off (EPO) interface supports emergency shutoff in large facilities
Hot-swappable/user replaceable batteries allow on-site battery replacement without powering off connected equipment
UPS battery set ships fully assembled and ready for use, no time consuming, connection of individual internal batteries by user is
necessary
Specifications
OUTPUT
Output Volt Amp Capacity
(VA)
2200
Output kVA capacity (kVA)
2.2
Output Watt Capacity
(watts)
1600
Output kW capacity
1.6
Output power factor
0.7
Nominal Output Voltage(s)
Supported
120V
Frequency compatibility
60 Hz
Output voltage regulation
(line mode)
-18% / +8%
Output voltage regulation
(Battery mode)
+/- 5%
Built-in UPS output
receptacles
7 5-15R outlet(s); 2 5-15/20R outlet(s); 1 L5-20R outlet(s)
Built-in controllable
switched load banks
Three switchable single-outlet 5-15R load banks
Output AC waveform (AC
mode)
Sine wave
Output AC waveform
(battery mode)
PWM sine wave
INPUT
Rated input current (at
maximum load)
16A
Nominal Input Voltage(s)
Supported
120V AC
UPS input connection type
5-20P
Input circuit breaker
20A
UPS Input cord length (ft.)
8
UPS Input cord length (m)
2.4
Recommended Electrical
Service
20A 120V
BATTERY
Full load runtime (minutes)
7 min. (1600w)
