7
5. Enclosure Configuration
5.2 Reversing Doors
1
2
1
Remove the screw connecting the ground wire to the inside of the door.
2
Remove the combination lock, cam and screw plate from the door of the enclosure as shown.
3
4
6
5
3
Remove the doors by following the steps in the previous section.
4
Remove the door hinges from the enclosure, rotate them 180 degrees and attach them on the
opposite side of the enclosure.
Note:
The alternate door hinge attachment points have plastic plugs in the screw holes. Remove the plugs
and insert them in the original door hinge attachment points.
5
Unscrew the 2 hinge mechanisms from the hinge openings inside the door, then reattach each
of them using the set of screw holes immediately opposite their original position.
6
Rotate the door 180 degrees and reinstall it on the enclosure. Remember to connect the ground
wire to the inside of the door, using the attachment point nearest the hinge at the top of the
door. The attachment point is marked with the ground connection symbol: .
