5
5. Enclosure Configuration
continued
6. Wall Mounting the Enclosure
5.4 Mounting Rails
5.5 Adjusting Mounting Rail Depth
The enclosure comes with mounting rails that have square holes (default position) and tapped holes
for mounting rack equipment. To install equipment, use the included cage nuts and other hardware.
(See page 6 for installation of cage nuts.)
Warning: Be sure to have the enclosure securely
mounted to the wall, or in its final position on the floor before mounting any
equipment inside. Also be sure to have all the right adjustments on your rails before
mounting equipment. (See below for Adjusting Mounting Rail Depth.)
Warning: Do not attempt to adjust rails while equipment is installed in the enclosure.
Do not attempt to use rails without screws installed. (2 per rail.)
The 2 mounting rails are pre-installed to accommodate standard equipment. Do not adjust the
mounting rails unless your equipment requires a different mounting depth.
1
Each rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper
corner and another in the lower corner. Using a Phillips-head screwdriver, remove the screws
that fasten the rails to the enclosure.
2
Move cage nuts to desired depth and reinstall.
3
Slide the mounting rails to the desired depth and reattach them using the screws you removed in
Step 1.
Warning: Do not attempt to mount the enclosure to the wall with equipment mounted in the enclosure.
Before mounting, use a level and tape measure to position your mounting area precisely. Be sure to
use appropriate fasteners (not included) to secure the enclosure to the wall.
Warning: The area
you plan to mount the enclosure to must be able to withstand the weight of the
enclosure and all mounted equipment.
1
Using user-supplied hardware, attach the mounting plate to a wall or other suitable mounting
surface. Each mounting hole can accommodate an M8 or 5/16” bolt and the holes are spaced
16" apart to accommodate standard stud placement as reflected in the diagram.
Note: When
mounting the mounting plate to the wall, be sure the three mounting hooks are facing outwards
and away from the wall.
2
After the mounting plate has been securely attached to the mounting surface, hang the
enclosure’s three mounting notches onto the three mounting hooks on the plate attached to the
wall. The notches will fit over the hooks and the enclosure should slide down onto the hooks
until secure.
Note: Mounting notches exist on both the upper and lower rails of the back panel.
This allows for mounting in the standard or reversed positions.
3
After the mounting plate has been secured and the enclosure hung properly, secure the
enclosure to the mounting plate by installing the three supplied screws in the holes on the
mounting hooks as shown.
16”
2.75”
2.75”
16”
A
A
B
B
C
C
1
3
2
1
2
3
12-11-205-93-327F.indd 5
12/21/2012 1:30:51 PM
