5
Enclosure Installation
Unpacking
(continued)
4
Use the key to open the enclosure's doors and locate the 2 shipping brackets
A
that attach the enclosure to
the shipping pallet. The brackets are located inside the enclosure. Note: The keys are attached to the front of
the enclosure.
5
Use a 13 mm open-end wrench to remove the shipping brackets. Be extremely careful, as the enclosure
could shift unexpectedly after bracket removal. Save the brackets and bracket hardware for later use.
6
Position at least one person at the front of the enclosure and one person at the rear of the enclosure. Slowly
push the enclosure toward the back of the shipping pallet until all four casters go over the edge of the
pallet and touch the floor. WARNING: Use at least one assistant when removing the enclosure from
the pallet. Be extremely careful when moving the enclosure.
Placement
1
Use the casters to move the enclosure for a short distance over a level, smooth, stable surface by pushing it
from the front or rear (not the side panels). Do not attempt to roll the enclosure over long distances. The
enclosure should be moved close to its installation location inside its shipping container before it is
unpacked. (Use a forklift or pallet jack to move the shipping container.) WARNING: Do not push or pull
the enclosure at the side panels or pull the enclosure toward you.
If required, the enclosure can be lifted by attaching 4 user-supplied M8 diameter eye bolts to the threaded
holes near the upper corners of the enclosure frame. Use steel bolts with an ISO strength rating of 8.8 or
higher. The 4 bolts can support the weight of the enclosure and up to 1000 lb (450 kg) of installed
equipment. WARNING: Only experienced equipment operators should attempt to lift the enclosure.
Use appropriate equipment and follow all applicable safety procedures and regulations.
A
4
5
6
1
201112001_L 93-2723.indd 5
12/14/2011 11:27:16 AM
