7
6. Mounting the Enclosure
continued
6.2 Tabletop/Floor Mounting
1
There are four mounting holes on the bottom of the enclosure. Each hole can accommodate an
M8 or 5/16” bolt. The holes are spaced 21.9” (557 mm) apart horizontally and 10.8”
(275 mm) apart vertically, as shown in the diagram.
2
Using a tape measure, identify the tabletop or floor location where you want to position your
enclosure and mark two mounting holes 21.9” (557 mm) apart horizontally and 10.8” (275
mm) apart vertically. Remove the enclosure’s top panel. Then align the enclosure with the
marking holes and secure the enclosure using four M8 or 5/16” bolts.
Note:
Depending on surface, pilot holes may need to be drilled prior to hardware installation.
1
2
