43
8. LCD Display and Settings
7. Control & Test
Route: Main Screen
Setting
CONTROL&TEST
FORCE BYPASS TRANSFER:
Enables or disables the Force Bypass Transfer. The default setting is YES.
AUTO RESTART:
Enables or disables Auto Restart. If set to ON, the UPS will shut down and automatically restart. The default setting is ON.
Use function keys (
), (
) and (
) to change the CONTROL&TEST setting.
8. Parallel Setup
Route: Main Screen
Setting
PARALLEL SETUP
PARALLEL ID:
Every parallel UPS system’s PARALLEL ID should be different. When UPS systems are in a parallel configuration, you can
change the PARALLEL ID to avoid ID confict. There are four settings: 01, 02, 03 and 04.
Use function keys (
), (
) and (
) could change the setting of PARALLEL ID.
9. Advanced
Route: Main Screen
Setting
ADVANCED
CLEAR STATISTICS:
Includes RUN TIME, ON BAT COUNTS, ON BYPASS COUNTS, and TOTAL EVENT COUNTS. You can clear statistics of
all the above items.
FIRMWARE UPGRADE:
This option upgrades the firmware. There are two choices to upgrade: PFC and SYSTEM
Use function keys (
), (
) and (
) to change the ADVANCED setting.
8.3 Parallel Screen
When UPS systems are paralleled, press either the function key (
) or (
) in a
Main Screen
to enter into the
Parallel
Screen
:
ID
MID
INV
ON
1 2 3 4
• ID:
In parallel mode, this is the UPS ID number.
• MID:
Master UPS ID number. (In parallel mode, there is only one master UPS).
• INV:
“ ” means “CONNECTED”.
• ON:
“ ” means “INVERTER ON”.
