background image

6

FCC Part 68 Notice (U.S. only)
If your Fax Modem Protector causes harm to the telephone network, the telephone company may temporarily discontinue your service. If possible,
they will notify you in advance. If advance notice isn’t practical, you will be notified as soon as possible. You will be advised of your right to file
a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the
proper operation of your equipment. If it does, you will be given advance notice to give you an opportunity to maintain uninterrupted service. If
you experience trouble with this equipment, Fax Modem Protector, please contact the Manager of Technical Support; Tripp Lite; 1111 W. 35th
Street, Chicago, Illinois 60609; Phone: (773) 869-1234, for repair/warranty information. The telephone company may ask you to disconnect this
equipment from the network until the problem has been corrected or you are sure the equipment is not malfunctioning. There are no repairs that
can be made by the customer to the Fax Modem Protector.  This equipment may not be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs. (Contact your state public utility commission or corporation commission for information.)

TE 300

TE 700L

Output Capacity (VA/Watts):

300/200

700/450

Battery Runtime (Half Load/Full Load) Minutes:

86/37

83/35

Battery Recharge Time:

2-4  hrs.

2-4  hrs.

Approvals:

UL, cUL, NOM

UL, cUL, NOM

Modem/Fax Protection (starts at 260V):

1 line

 –

ALL MODELS:
Input Voltage/Frequency (120V/60 Hz); On Battery Output Voltage Range (120V +/- 5%); Output Waveform Line Mode (filtered sine
wave); Output Waveform Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise
Attenuation (>40 dB); AC Protection Modes (H to N, H to G, N to G)

Specifications

Storage & Service

Storage

First turn your UPS OFF and disconnect its power cord from the wall outlet. Then
disconnect all equipment to avoid battery drain. If you plan on storing your UPS
for an extended period of time, fully recharge the UPS batteries once every three
months by plugging the UPS into a live AC outlet and letting the UPS charge for
4 to 6 hours.  If you leave your UPS batteries discharged for an extended period
of time, they will suffer a permanent loss of capacity.

Service

If returning your UPS to Tripp Lite, please carefully pack the UPS using the
ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter
describing the symptoms of the problem. If the UPS is within the 2 year warranty
period, enclose a copy of your sales receipt.

Battery Replacement Door

Under normal conditions, the original battery in your UPS will last
several years. Battery replacement should be performed only by
qualified service personnel. Refer to “Battery Warnings” in the
Safety section on page 2.

Summary of Contents for TE-300







Reviews: