6
Modifying Your Password
To change your password, follow these steps:
1.
Press and hold the “*” button. At the same time,
connect the included USB cable between the
USB port on the unit and a USB port on the host
computer. After approximately 5 seconds, the red,
green and orange LEDs will illuminate.
2.
Enter the old password and press the “#”
button to enter. Only the red and green LEDs will
illuminate.
3.
Enter the new password and press the “#” button
to save. The blue LED will blink while the red and
green LEDs remain illuminated.
4.
Reenter the new password and press the “#”
button to confirm the password change was
successful. The blue LED will blink. The red and
green LEDs will then illuminate to indicate a
successful password change.
16-11-238-933690.indb 6
12/20/2016 4:20:37 PM
