Operation
MicronNav System
0656-SOM-00001-07
62
© Tritech International Ltd.
Select ‘Finish’ to save the settings and start the new Job, or Cancel (All settings will be lost).
4.1.5. Editing an Existing Job
If accurate true world positional information is required it is necessary to set up a Job
containing all the installation offsets between each part of the navigation system as measured
in the previous section.
If an existing Job exists for the operating site but some of the parameters is changed then it
is possible to make changes to this Job using the Edit Job function.
Note
To retain an existing Job, but create a new Job from its settings then use ‘Create
New Job’ and select either Use Last or Recent Job Settings (Section 4.1.4,
“Creating a New Job (Using Wizard)”)
Select MicronNav from the top menu bar (if this menu option is not displayed click inside the
Navigation window first) followed by Job – Edit Job to open the ‘Edit Job’ window (if the Edit
Job panel is too small to show the whole form, press the F2 key to maximise the MicronNav
application).
The ‘Edit Job’ form is where the user can review and make changes to an existing Job.
