TriTeq MicroIQ CM, Operation Manual

3

MicroIQ Electronic Lock Programming Guide

Programming a New Master Code

Warning:  

Do not

 set your 

Master Code

 to 1-2-3-4-5.  Doing so will 

erase

 all existing 

Access Codes

 and reset 

User ID

 1-1 to 

Access Code

 1-1-1-1-1.

If a valid 

Master Code

 is entered, the green, red, and yellow  

LEDs will flash.

If an invalid 

Master Code

 is entered, the red LED will flash 3 

times, and the keypad will exit programming.

Once the new 

Master Code

 is programmed, the 1-2-3-4-5 

Factory 

Code

 becomes invalid.

Note:

 All 

Access Codes

 remain the same when a new 

Master Code

 is 

programmed.

1. 

With the lock in either unlocked or locked position, press and 

The keypad will enter 

programming mode

, and the green LED 

will light up.

2.  Enter your 5-digit 

Master Code

If the code is entered correctly, the green LED will light up.  
Proceed to step 3.

If no code is entered within 10 seconds, or if the code is entered 
incorrectly, then the red LED will flash 3 times, and the keypad 
will exit 

programming mode

.

3.  Press and hold the 

Program Button

 for 5 seconds.

The keypad will enter 

programming mode

.  The red LED will 

flash once, and then the green and yellow LEDs will light up.

4.  Enter the desired 5-digit 

Master Code

.

MY MASTER CODE:  __ - __ - __ - __ - __

Programming Instructions

hold the 

Program Button

 (located below the #3 button) for 5  

seconds.