4
MicroIQ Electronic Lock Programming Guide
Programming Instructions
Adding a Control Key-Fob
Note:
The
Factory Code
should be
changed to a new
Master
Code
before proceeding
with the programming
a
Control Key-Fob
.
Now you can use the
Control Key-Fob
to operate the lock.
1.
With the lock in either unlocked or locked position, press and
hold the
Program Button
(located below the #3 button) for 5
seconds.
The keypad will enter
programming mode
, and the green LED
will light up.
2. Enter your 5-digit
Master Code
If the code is entered correctly, the green LED will light up.
Proceed to step 3.
If no code is entered within 10 seconds, or if the code is entered
incorrectly, then the red LED will flash 3 times.
To try again, return to step 1.
3. Press and hold the
Program Button
for 5 seconds.
The red LED will flash once, and then the green and yellow LEDs
will light up.flash once, and then the green and yellow LEDs will
light up.
4.
Point your
Control Key-Fob
under the
Program Button
and press
the center button of the fob.
A
Control Key-Fob
can be used insted of the
keypad to open or program the lock.
A
Control Key-Fob
can be paired to as many
MicroIQ locks as desired.