Programming Instructions
7
MicroIQ Electronic Lock Programming Guide
Deleting Access Codes
Warning:
This will erase all
Access Codes
& reset the lock back to the
1-1-1-1-1
Access Code
under User ID 1-1 when complete.
It will not change the
Master Code.
To delete all Access Codes:
1.
2.
With the lock in either the locked or unlocked position, press
and hold the
Program Button
(located below the #3 button) for
5 seconds.
3.
Enter the valid 5-digit
Master Code.
4.
Press and hold the
Program Button
for 5 seconds again
Enter 1-2-3-4-5.
Changing Access Codes
Each
Access Code
is saved under a User ID location. This procedure
will replace an existing
Access Code
based on the code’s
User ID
location, making the original
Access Code
located under that
User ID
permanently obsolete.
To
change
an
Access Code
:
1.
2.
With the lock in either the locked or unlocked position, press and
hold the
Program Button
(located below the #3 button) for 5
seconds.
3.
Enter the valid 5-digit
Master Code
.
4.
Enter the 2-digit
User ID
location* you wish to replace/change
(found in the table on page 6).
Enter the new 5-digit
Access Code
.
Repeat steps 1 - 4 to change additional
Access Codes.
*Reference the
User ID
found in the table on page 6.
