-
８
- XM089-V1.0-NR
OFF ON OFF
Stand Master by Sound Mode:
No matte what value set from DP1
to DP8, this unit work in Stand Master by Sound activated.
(Status indicator-
Red green flash)
ON ON OFF
Master by Auto run Mode:
No matte what value set from DP1 to
DP8, this unit work in Master by Auto run activated.
(Status indicator- Red green flash)
Control via a standard DMX-512 controller
:
When you use a DMX controller to control the strobe, please refer to the channel functions as the
following:
DMX channel´s functions and their values (2 DMX channels):
Channel 1 - Speed
0-1
Close
2-5
Spring strobe
6-255
Strobe slow to fast
Channel 2 - Dimmer
0-9
Close
10-255
Intensity 0-100%
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other
side to the male 3-pin XLR input of the moving head. You can chain multiple
Moving head together through serial linking. The cable needed should be two core,
screened cable with
XLR input and output connectors. Please refer to the diagram below.
The DMX starting address of the controller is defined by the first 9 DIP switches.
The encoding is binary: DIP switch 1 value 1 (2º=1), DIP switch 2 value 2 (2¹=2), DIP switch 3
value 4 (2²=4), DIP switch 4 value8 (2³=8), etc…
Example: if 95 were the desired start address, then the settings for the first 9 switches would be as
follows: 111111101 = 1 + 2 + 4 + 8 + 16 + 0 + 64 = 95.
You can set the address 95 by pushing the pin 1, 2, 3, 4, 5, 7 to the position “ON”.
