Triton 10.5kW, Installation And Operating Instructions Manual

18

Electric shower

OPERATING THE SHOWER 

(fig.19)

When the electricity supply to the shower is 
switched on at the isolating switch, the power 
indicator will light up.

The 

START/STOP, HIGH, ECONOMY OR 

COLD

 control buttons may be pressed to start 

the shower.

NOTE: 

The shower starts as a default on the 

HIGH

 setting if the 

START/STOP 

button is 

used.

To stop the shower press the 

START/STOP

button and the phased shutdown will begin. 
Water will cease to flow after approximately 5  
seconds.
The 

HIGH

 setting allows the highest flow 

achievable for your preferred temperature. This 
setting should normally be regarded as optimum 
shower performance throughout the year.
The 

ECONOMY

 setting uses less energy when 

the ambient mains water temperature is high 
during hot months.

NOTE:

 The preferred control position on 

ECONOMY will give a different temperature to 
the same position on HIGH.
The 

COLD

 setting is for cold water only. 

Adjusting the temperature flow control at this 
setting will only increase or decrease the flow of 
the water from the shower head, it will not alter 
the water temperature.

IMPORTANT:

It will take a few seconds for the 

temperature to stabilise once changes have 
been made.

NOTE:

If the stated flow rate required for the 

unit cannot be met due to low water pressure, 
it will be necessary to operate the unit on the 
Economy setting during the warmer months 

because of flow rate limitations entering the 
unit.

Temperature Adjustment

 The water temperature is altered by increasing or 

decreasing the flow rate of the water through the 
shower via the temperature flow control. Turning 
the control 

anti-clockwise

 will increase the flow 

of water through the shower and make the water 

cooler

.

Turning it 

clockwise

 will decrease the 

flow and make the water 

hotter.

Fig.19

Start/stop 

button

Power 

indicator

Cold

Economy

High

Hotter

Colder