A
Q U A S E N S A T I O N
A S 2 0 0 0 T / A S 2 0 0 0
2
INTRODUCTION
This book contains all the necessary fitting and
operating instructions for your Triton
Aquasensation thermostatic or manual power
shower. Please read them carefully.
Please note that both models are outwardly
similar. The thermostatic version – AS2000T is only
identifiable by having ‘thermostatic’ graphic on
the cover, above the controls. The manual AS2000
shower does not have this graphic and does NOT
contain a thermostatic valve.
Some illustrations in this book depict the
thermostatic model but the instructions will apply
to both models, unless otherwise stated.
The shower installation must be carried out by
suitably competent person and in sequence of this
instruction book.
Care taken during the installation will ensure a
long and trouble free life from your shower
Important:
All plumbing connections must be
completed BEFORE making the electrical
connections.
Please read through the whole of this book before
beginning your installation.
Important:
The fittings on the pipe inlet elbows
are of the push-in type. The pipework must be cut
with a pipe cutter and all burrs and rough edges
removed from the end of the tube. The fittings
can be used with copper and plastic pipe.
Where chrome plated pipe is used, remove the
first 25mm of plating.
NOTE: The pump inside this product is rated 15
minutes on / 45 minutes off duty cycle.
SAFETY WARNINGS
a
Do not insert fingers into the push-in inlet
fittings. Doing so could cause injury.
b
Under no circumstances must this product
be connected to mains cold or hot water
supplies.
Failure to comply will invalidate the
guarantee.
c
The shower MUST NOT be used if suspected
of being frozen.
d
The outlet of this appliance must not be
connected to any form of tap or fitting not
recommended by the manufacturer.
e
The sprayhead cartridge must be cleaned
regularly to remove scale and debris.
f
This appliance must be earthed.
g
Switch off immediately at the isolating switch
if water ceases to flow during use.
h
Do not operate the shower outside the
guidelines laid out in ‘site requirements’.
WARNING: The manual AS2000 shower does
not contain a thermostatic valve – it will not
shut off in the event of failure of either the
hot or cold water supplies.
Replacement parts can be ordered from Triton
Customer Service. See
‘spare parts’
for details and
part numbers.
In the interest of electrical safety a 30mA
residual current device (RCD) should be
installed in all UK 230V electric and pumped
shower circuits. This may be part of the
consumer unit or a separate unit.
Due to continuous improvement and updating,
specification may be altered without prior notice.
Summary of Contents for Aquasensation AS2000
Page 28: ...UKAS QUALITY MANAGEMENT 003 ...