Triton ASPIRANTE XR, Installation And Operating Instructions Manual

Aspirante xr

11

FITTING THE SHOWER TO THE WALL

Note:

 The control knob is an integral part of the 

cover – DO NOT attempt to remove it.
Lift the cover from the backplate. To access the 
pipe and cable connections lift off the trimplate 

(fig.7)

.

Entry positions for the mains water are from the 
bottom, rear or side. Cable entry is via the top 
or rear.

Note:

 Deviations from the designated entry 

points will invalidate product approvals.
If bottom or side surface entry is required for the 
mains cold water, then the necessary opening 
will need to be cut out in the trimplate 

(fig.8)

.

If surface cable entry from the top is required 
then a small area will need to be cut out in the 
backplate

 (fig.9)

.

If installing a feed pipe from the rear, bottom 
or side the centre of the inlet valve to the wall 
surface is 21mm 

(fig.10)

.

Note:

 If entry is from the rear, the nut of the 

compression fitting will be partially behind the 
surface of the wall 

(fig.10)

. This area MUST 

be left clear when plastering over the pipework 
in order to make the nut accessible for future 
adjustments.

IMPORTANT:

 Always seal around the 

incoming pipework to prevent water entering 
the wall.

After choosing the site for the shower, use the 
backplate as a template and mark the two fixing 
holes 

(fig.11)

.

WARNING!

Check there are no hidden cables or 

pipes before drilling holes for wall 

plugs. Use great care when using 

power tools near water. The use of 

a residual current device (RCD) is 

recommended.

Area to be

cut away for

side entry

Area to be cut away

for bottom entry

Fig.8

Fig.7

Fig.9

Fitting the shower to the wall

FITTING THE SHOWER TO THE WALL