Triton ASPIRANTE XR, Installation And Operating Instructions Manual

Aspirante xr

14

L    N

Terminal

block

L

N

E

1

2

3

5

7

6

inlet

outlet

9

9

4

8

10

11

1.

   Terminal block

2.

   Earth post

3.

   Control PCB

4.

   Power PCB

5.

   Solenoid Valve

6.

   Thermal cut-out

      (main)

7.

     Thermal cut-out

        (outlet)

8.

     Connector socket

9.

     Element

10.

   Power LED

11.

   Low Pressure LED

ELECTRICAL CONNECTIONS

SWITCH OFF THE ELECTRICITY SUPPLY AT 
THE MAINS.

Fig.12

 shows a schematic wiring diagram.

The cable entry points are shown in 

fig.1

. The 

cable can be surface clipped, hidden or via 
20mm conduit.

Note:

 Conduit entry can only be from rear. 

Route the cable into the shower unit and 
connect to the terminal block 

(fig.13)

 as 

follows:

Earth cable to terminal marked  

Neutral cable to terminal marked  

N

Live cable to terminal marked

  L

IMPORTANT:

 Fully tighten the terminal 

block screws and make sure that no cable 
insulation is trapped under the screws. Loose 
connections can result in cable overheating.

Note: 

The supply cable earth conductor must 

be sleeved. The outer sheath of the supply cable 
must be stripped back to the minimum.
The supply cable must be secured either by 
routing through conduit or in trunking or by 
embedding in the wall, in accordance with 
current IEE regulations.

The use of connections within the unit, or other 
points in the shower circuit, to supply power to 
other equipment i.e. extractor fans, pumps etc. 
will invalidate the guarantee.

DO NOT switch on the electricity supply until 
the cover has been fitted.

Note:

 The elements on UK models are to 

240V specification and will give a lower kW 
rating if the voltage supply is below 240V.

Fig.13

Fig.12

Electrical connections

ELECTRICAL CONNECTIONS