Triton ASPIRANTE XR, Installation And Operating Instructions Manual

Aspirante xr

23

FAULT FINDING

IMPORTANT:

 Switch OFF the electricity at the mains supply and remove the circuit fuse before 

attempting any fault finding inside the unit.

Problem/Symptom Cause 

Action/Cure

1 

Shower 
inoperable, no 
water flow. 
 
 
 

2 

Water too hot. 
 
 

3

 Water 

temperature 
cycling hot/cool 
at intervals.

4

  Water too cool 

or cold.

1.1 

Interrupted power 
supply. 
 
 
 
 

1.2 

Unit malfunction.

2.1 

Not enough water 
flowing through the 
shower. 

2.2 

Blockage in supply. 

2.3 

Increase in ambient 
water temperature. 

3.1 

Heater cycling on 
outer temperature 
limiter. 

4.1 

Too much flow.

4.2 

Water pressure below 
minimum stated on 
rating label. 
 
 
 
 
 
 
 
 

4.3 

Reduction in ambient 
water temperature. 

1.1.1 

Blown fuse or circuit breaker. Check 
supply. Renew or reset fuse or circuit 
breaker. If it fails again, consult a qualified 
electrician.

1.1.2 

Power cut? Check other appliances and 
if necessary, contact the local Electricity 
Supply Company.

1.2.1 

Have unit checked. Ring Customer Service.

2.1.1 

Increase the flow rate via temperature 
control.

2.1.2 

Blocked showerhead – clean blocked 
sprayplate.

2.2.1 

Check if stop valves are fully open. Check 
if blockage in inlet filter.

2.3.1 

Switch to economy power setting and 
readjust flow rate to give required 
temperature.

3.1.1 

See 

'Water too hot'

 causes 2.1, 2.2 and 

2.3 and their action/cures. If it continues, 
contact Customer Service. 

4.1.1 

Reduce flow rate via temperature control.

4.2.1 

Check low pressure indicator. If lit, 
continue with remainder of checks. If not 
lit, see 4.1 & 4.4.

4.2.2 

Is water supply mains or tank fed?

4.2.3 

If tank fed, replumb to mains water supply 
or see 4.2.5.

4.2.4 

If mains fed, make sure the mains stop 
valve is fully open and that there are 
no other restrictions in the supply while 
shower is in use, or see 4.2.5.

4.2.5 

Fit a pump to give minimum pressure; 
contact Customer Service for advice.

4.3.1 

Switch to full power setting and readjust 
the flow rate via the temperature control 
to give required temperature.