7
GB
For the next few steps, fit the notched windows
(with the '5-10' designation reading right way up)
to both sides of the main body by inserting them
into slots beside each window opening. Use the
safety guards to push them fully home. (Fig.2)
Step 5:
Fit the biscuit joiner back onto the table.
With the power cord disconnected, push in the
safety guards and check that the cutter clears
the guards and the plastic windows.
At full extension the cutter should protrude
13mm from the face of each window (Fig.3). Use
a screwdriver to adjust the depth stop screws
on the underside of the sliding insert, inward or
outward, until 13mm is achieved (Fig.4).
In use:
You can adjust the stops to limit the travel for
shallower slots in thin material, using cut down
biscuits.
Step 6:
Fit the Sliding Guide Clamp (R) to the Sliding
Guide (G), using a Coach Bolt (S) and Round Knob
(T).
With the knob loosened, you can slide the guide
on and off the main body. Tightening the knob
locks the guide to the main body (Fig.5)
Dust Extraction
The biscuit joiner has been designed for use with
a vacuum cleaner for sawdust extraction. It can
be used without dust extraction, but you will need
to lift the main body after every 20-30 cuts to
clean out accumulated shavings.
While any vacuum cleaner can be used ,
domestic (bag-type) units can fill up very quickly.
For a much larger capacity, we recommend
fitting a Triton Dust Collector (DCA300) to your
vacuum cleaner.
Screw the vacuum hose (left-hand thread),
supplied with your router table, onto the dust port
at the end of the main body and plug the wand of
your vacuum cleaner into the hose adaptor.
Power Connection Warning
The combined electrical load of your router and
vacuum cleaner may exceed the rated amperage
of your domestic extension lead or power outlet.
Therefore you should connect your vacuum
cleaner and router to separate outlets, and switch
on both appliances separately.
Safety
• Always work in a well lit, uncluttered
environment.
• Always wear safety glasses and hearing
protection.
• Make sure the Router Table is securely locked
down to your Workcentre or Router Stand.
• Always switch off the power and/or disconnect
the power cord when fitting or adjusting the
cutter or raising the main body.
• Always keep hands clear of the cutter
apertures in the main body and never operate
Assembly
Fig.2
Fig.3
Fig.4
Fig.5
