3NG
1-5-4
10. Remove the stop ring from the paper
feed pulley axis.
11. Pull out the paper feed pulley axis and
remove the torque limiter, SD paper
feed pulley and one way clutch.
Figure 1-5-5
12. Remove two stop ring from the SD for-
warding pulley axis.
13. Pull out the SD forwarding pulley axis
and remove the SD forwarding pulley,
one way clutch.
14. Clean or replace the SD forwarding pul-
ley, SD paper feed pulley.
15. Refit the SD forwarding pulley, SD
paper feed pulley to the SD paper feed
unit.
Figure 1-5-6
One way clutch
SD paper feed pulley
Torque limiter
Paper feed pulley axis
Stop ring
Paper feed pulley holder
SD forwarding pulley
SD forwarding
pulley axis
One way clutch
Paper feed pulley holder
Stop ring
Summary of Contents for Utax PF 770
