Assembly Tips:
Attention:
If you are using an electric screwdriver in the assembly, please set at low torque
and do not over tighten the hardware. When assembling individual parts, loosely tighten screws
until all screws are inserted, then tighten completely. Do not strip out screws.
Assembly Instructions
Find a clean, level place to begin the assembly of your Air Hockey table.
Leave Air Hockey Table Cabinet
(P1)
face down in the carton to assemble.
Remove all the parts from the box and verify that you have all of the listed parts as shown
on the parts identifier page. Carefully cut or tear the four corners of the box so that the
bottom of the box can be used as your work surface.
Attach the Left Legs
P2
and Right Legs
P3
to the Air Hockey Cabinet
P1
using Allen Head Bolts
H1
and Flat Washers
H2
as shown in
FIGURE 1
. Use Allen Wrench
T1
to tighten Bolts.
PARTS REQUIRED:
1 pc -
P1
Air Hockey Cabinet
2 pcs -
P3
Right Leg
12 pcs -
H1
8mm x 35mm Allen Head Bolt
12 pcs -
H2
8.5mm x 22mm Flat Washer
2 pcs -
P2
Left Leg
P3
C1 Air Motor w/ ON/OFF
switch in the powercord
H1
H2
P3
P2
P2
FIGURE 1
STEP:1
5
